The STDS75 is a high-precision CMOS (digital) temperature sensor IC with a delta-sigma analog-to-digital (ADC) converter and an I²C-compatible serial digital interface. It is targeted for general applications such as personal computers, system thermal management, electronics equipment, and industrial controllers, and is packaged in the industry-standard 8-lead TSSOP package.The device contains a bandgap temperature sensor and programmable 9- to 12-bit ADC which monitor and digitize the temperature to a resolution up to 0.0625 °C. The STDS75 is typically accurate to (±3 °C - max) over the full temperature measurement range of –55 °C to 125 °C with ±2 °C accuracy in the –25 °C to +100 °C range. At power-up, the STDS75 defaults to 9-bit resolution for software compatibility with the STLM75.The STDS75 is specified for operating at supply voltages from 2.7 V to 5.5 V. Operating at 3.3 V, the supply current is typically (125 µA).The onboard delta-sigma analog-to-digital converter (ADC) converts the measured temperature to a digital value that is calibrated in °C; for Fahrenheit applications a lookup table or conversion routine is required.The STDS75 is factory-calibrated and requires no external components to measure temperature.Measures temperatures from –55 °C to +125 °C (–67 °F to +257 °F)±0.5 °C (typ) accuracy±2 °C (max) accuracy from –25 °C to +100 °CLow operating current: 125 µA (typ)No external components required2-wire I²C/SMBus-compatible serial interfaceSelectable serial bus address allows connection of up to eight devices on the same busThermometer resolution is user-configurable from 9 (default) to 12 bits (0.5 °C to 0.0625 °C)9-bit conversion time is 150 ms (max)Programmable temperature threshold and hysteresis set pointsWide power supply range - operating voltage range: 2.7 V to 5.5 VPin- and software-compatible with DS75 (drop-in replacement)Power-up defaults permit standalone operation as thermostatShutdown mode to minimize power consumptionSeparate open drain output pin operates as an interrupt or comparator/thermostat output (dual purpose event pin)