IPS161H
ActiveCURRENT LIMIT SW 1-IN 1-OUT 6.9V TO 60V 1.7A 12-PIN POWERSSO EP TUBE
Deep-Dive with AI
Search across all available documentation for this part.
IPS161H
ActiveCURRENT LIMIT SW 1-IN 1-OUT 6.9V TO 60V 1.7A 12-PIN POWERSSO EP TUBE
Deep-Dive with AI
Technical Specifications
Parameters and characteristics for this part
| Specification | IPS161H |
|---|---|
| Current - Output (Max) [Max] | 1.7 A |
| Fault Protection | Over Temperature, UVLO, Open Load Detect, Current Limiting (Fixed) |
| Interface | On/Off |
| Mounting Type | Surface Mount |
| Number of Outputs | 1 |
| Operating Temperature [Max] | 125 °C |
| Operating Temperature [Min] | -40 C |
| Output Configuration | High Side |
| Output Type | P-Channel |
| Package / Case | 12-LSOP (0.154", 3.90mm Width) Exposed Pad |
| Ratio - Input:Output | 1:1 |
| Rds On (Typ) | 60 mOhm |
| Supplier Device Package | PowerSSO-12 |
| Switch Type | General Purpose |
| Voltage - Load [Max] | 60 V |
| Voltage - Load [Min] | 8 V |
| Voltage - Supply (Vcc/Vdd) | Not Required |
IPS161H Series
Single high-side switch
| Part | Current - Output (Max) [Max] | Voltage - Supply (Vcc/Vdd) | Switch Type | Package / Case | Operating Temperature [Min] | Operating Temperature [Max] | Rds On (Typ) | Voltage - Load [Min] | Voltage - Load [Max] | Output Type | Number of Outputs | Mounting Type | Fault Protection | Interface | Ratio - Input:Output | Supplier Device Package | Output Configuration |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
STMicroelectronics | 1.7 A | Not Required | General Purpose | 12-LSOP (0.154" 3.90mm Width) Exposed Pad | -40 C | 125 °C | 60 mOhm | 8 V | 60 V | P-Channel | 1 | Surface Mount | Current Limiting (Fixed) Open Load Detect Over Temperature UVLO | On/Off | 1:1 | PowerSSO-12 | High Side |
STMicroelectronics | 1.7 A | Not Required | General Purpose | 12-LSOP (0.154" 3.90mm Width) Exposed Pad | -40 C | 125 °C | 60 mOhm | 8 V | 60 V | P-Channel | 1 | Surface Mount | Current Limiting (Fixed) Open Load Detect Over Temperature UVLO | On/Off | 1:1 | PowerSSO-12 | High Side |
Pricing
Prices provided here are for design reference only. For realtime values and availability, please visit the distributors directly
Description
General part information
IPS161H Series
The IPS160H (IOUT< 2.5 A) and IPS161H (IOUT< 0.7 A) are monolithic devices which can drive capacitive, resistive or inductive loads with one side connected to ground.
The 60 V operating range and Ron = 60 mΩ, combined with the extended diagnostic (Open Load, Over Load, Overtemperature) make the IC suitable for applications implementing the proper architectures to address higher SIL levels. The built-in overload and thermal shutdown protections guarantee the ICs, the application and the load against electrical and thermal overstress. Furthermore, in order to minimize the power dissipation when the output is shorted, a low-dissipative short-circuit protection (cut-off) is implemented to limit the output average current value and consequent device overheating.Cut-off delay time can be set by soldering an external capacitor or disabled by a resistor on pin 4 (CoD).
The DIAG common diagnostic open drain pin reports the open load in off-state, cutoff (overload) and thermal shutdown.