The ADG528A andADG529Aare CMOS monolithic analog multiplexers with eight channels and four dual channels, respectively. On-chip latches facilitate microprocessor interfacing. The ADG528A switches one of eight inputs to a common output, depending on the state of three binary addresses and an enable input. The ADG529A switches one of four differential inputs to a common differential output, depending on the state of two binary addresses and an enable input. Both devices have TTL and 5 V CMOS logic-compatible digital inputs.The ADG528A and ADG529A are designed on an enhanced LC2MOS process, which gives an increased signal capability of VSSto VDDand enables operation over a wide range of supply voltages. The devices can comfortably operate anywhere in the 10.8 V to 16.5 V single- or dual-supply range. These multiplex-ers also feature high switching and low RON.The ADG529A is no longer available.Product HighlightsSingle-/dual-supply specifications with a wide tolerance.The devices are specified in the 10.8 V to 16.5 V range for both single- and dual-supplies.Easily InterfacedThe ADG528A and ADG529A can be easily interfaced with microprocessors. TheWRsignal latches the state of the address control lines and the enable line. TheRSsignal clears both the address and enable data in the latches resulting in no output (all switches off).RScan be tied to the microprocessor reset pin.Extended Signal RangeThe enhanced LC2MOS processing results in a high breakdown and an increased analog signal range of VSSto VDD.Break-Before-Make SwitchingSwitches are guaranteed break-before-make so that input signals are protected against momentary shorting.Low LeakageLeakage currents in the range of 20 pA make these multiplexers suitable for high precision circuits.