Beta

⌘K

S

STMicroelectronics

Series	Category	# Parts	Status	Description

Part	Spec A	Spec B	Spec C	Spec D	Description

Standalone parts(2458)

...

Part	Category	Description
STMicroelectronics EMIF09-SD01F3Obsolete	Filters	FILTER RC(PI) 40 OHM/20PF SMD
STMicroelectronics STM32F412ZGJ7	Integrated Circuits (ICs)	STM32 DYNAMIC EFFICIENCY MCU WITH BAM, HIGH-PERFORMANCE AND DSP WITH FPU, ARM CORTEX-M4 MCU WITH 1 MBYTE OF FLASH MEMORY, 100 MHZ CPU, ART ACCELERATOR, DFSDM
STMicroelectronics SPC560D40L1B3E0X	Integrated Circuits (ICs)	32-BIT POWER ARCHITECTURE MCU FOR AUTOMOTIVE BODY AND GATEWAY APPLICATIONS
STMicroelectronics SPC560D30L1B4E0X	Integrated Circuits (ICs)	MCU 32-BIT E200Z0H RISC 128KB FLASH 3.3V/5V AUTOMOTIVE AEC-Q100 64-PIN LQFP T/R
STMicroelectronics STEVAL-CCA036V1	Development Boards Kits Programmers	DEMONSTRATION BOARD FOR SINGLE CHANNEL OP-AMP IN SO8 PACKAGE
STMicroelectronics LDLN025J30RLTB	Integrated Circuits (ICs)	IC REG LINEAR 3V 250MA 4FLIPCHIP
STMicroelectronics ST25RU3993-EVALObsolete	Development Boards Kits Programmers	ST25RU3993 READER IC EVALUATION BOARD
STMicroelectronics STM32F401CBY6TT	Integrated Circuits (ICs)	ARM-BASED 32-BIT MCU+FPU, 84MHZ, 128KB FLASH, 49-PIN WLCSP, -40 TO 85°C T/R
STMicroelectronics STP12NM60NObsolete	Discrete Semiconductor Products	MOSFET N-CH 600V 10A TO220AB
STMicroelectronics VND1NV04Obsolete	Integrated Circuits (ICs)	IC PWR DRIVER N-CHANNEL 1:1 DPAK

Series	Category	# Parts	Status	Description

P0111DA0.8 A - 600 V logic level SCR Thyristor in TO-92	SCRs	3	Active	Thanks to highly sensitive triggering levels, the P011xx SCR series is suitable for all applications where available gate current is limited, such as ground fault circuit interrupters, pilot circuits in solid state relays, standby mode power supplies, smoke and alarm detectors. Available in through-hole or surface-mount packages, the voltage capability of this series has been upgraded since its introduction and is now available up to 600 V.
P0115DASensitive 0.8 A 400 V SCR Thyristor in TO-92	Discrete Semiconductor Products	1	Active	Thanks to highly sensitive triggering levels, the P011xx SCR series is suitable for all applications where available gate current is limited, such as ground fault circuit interrupters, pilot circuits in solid state relays, standby mode power supplies, smoke and alarm detectors. Available in through-hole or surface-mount packages, the voltage capability of this series has been upgraded since its introduction and is now available up to 600 V.
P0118	Discrete Semiconductor Products	1	Obsolete
P0130	SCRs	1	Active
P6KE	Diodes	12	Obsolete
P6KE15CA600 W, 13 V TVS in DO-15	TVS Diodes	2	Active	The P6KE TVS series is designed to protect sensitive equipment against electrostatic discharges according to IEC 61000-4-2, MIL STD 883 Method 3015, and electrical overstress such as IEC 61000-4-4 and 5. They are used for surges below 600 W 10/1000 μs. This planar technology makes it compatible with high-end equipment and SMPS where low leakage current and high junction temperature are required to provide reliability and stability over time.
P6KE180A600 W, 154 V TVS in DO-15	Circuit Protection	1	Active	The P6KE TVS series is designed to protect sensitive equipment against electrostatic discharges according to IEC 61000-4-2, MIL STD 883 Method 3015, and electrical overstress such as IEC 61000-4-4 and 5. They are used for surges below 600 W 10/1000 μs. This planar technology makes it compatible with high-end equipment and SMPS where low leakage current and high junction temperature are required to provide reliability and stability over time.
P6KE18A600 W, 15 V TVS in DO-15	TVS Diodes	1	Active	The P6KE TVS series is designed to protect sensitive equipment against electrostatic discharges according to IEC 61000-4-2, MIL STD 883 Method 3015, and electrical overstress such as IEC 61000-4-4 and 5. They are used for surges below 600 W 10/1000 μs. This planar technology makes it compatible with high-end equipment and SMPS where low leakage current and high junction temperature are required to provide reliability and stability over time.
P6KE200CA600 W, 154 V TVS in DO-15	Circuit Protection	1	Active	The P6KE TVS series is designed to protect sensitive equipment against electrostatic discharges according to IEC 61000-4-2, MIL STD 883 Method 3015, and electrical overstress such as IEC 61000-4-4 and 5. They are used for surges below 600 W 10/1000 μs. This planar technology makes it compatible with high-end equipment and SMPS where low leakage current and high junction temperature are required to provide reliability and stability over time.
P6KE250CA600 W, 213 V TVS in DO-15	Circuit Protection	1	Active	The P6KE TVS series is designed to protect sensitive equipment against electrostatic discharges according to IEC 61000-4-2, MIL STD 883 Method 3015, and electrical overstress such as IEC 61000-4-4 and 5. They are used for surges below 600 W 10/1000 μs. This planar technology makes it compatible with high-end equipment and SMPS where low leakage current and high junction temperature are required to provide reliability and stability over time.