Diodes Inc

The PI3PCIE3415 is an 8 to 4 differential channel multiplexer/demultiplexer switch. This solution can switch 2 full PCI Express® 3.0, lanes to one of two locations. Using a unique design technique, Diodes has been able to minimize the impedance of the switch such that the attenuation observed through the switch is mininal. The unique design technique also offers a layout targeted for PCI Express signals, which minimizes the channel to channel skew as well as channel to channel crosstalk as required by the PCI Express specification. PI3PCIE3415 can also be used for application up to 12Gbps.

NRND = Not Recommended for New Design

PI3SSD1914 is designed to work in ONFI applications for advanced SSD SKUs. The purpose of the PI3SSD1914 is to effectively demultiplex ONFI-4 NAND commands and write data to one of the NAND ports as shown in Figure 1. The device also multiplexes the ONFI-4 NAND bus on a particular ONFI-4 NAND port to allow a selected target NAND bus to be routed to the host controller for data reads asshown in Figure 2. Each PI3SSD1914 mux/demux, four ONFI-4-compliant NAND ports with typical 12ns switching time and maximum500ps propagation delay. The core of the PI3SSD1914 operates at a supply voltage of 2.5V to 3.6V while the I/O interface circuits operate with an independent supply voltage from 1.2V to 1.8V. The supply voltage can be further reduced to 2.375V (min) for 1.2V VDDIO applications.

10.3 Gbps Thunderbolt & DisplayPort Switch

The PI3UPI1608 is an 8-differential channel linear ReDriver™that supports data rates up to 16Gbps. The device has an integrated 0.22uF coupling capacitors at both the ReDriver inputs and outputs to simplify signal routing and PCB layout. The linear ReDriver is protocol-agnostic and transparent to system link training. The on-chip CTLE equalizer, flat gain and output swing linearity settings provide programmable capability for signal integrity optimization on jitter reduction and eye opening. User can select either I2C control or pin-control mode to fit their system design.

Dual SPDT for USB 2.0 HS Compliance and Flow Through Pinout with 5V Protection

Dual SPST USB 2.0 Switch with VBUS Short Protection.

3.3V, 2-Channel, 4:1 Mux USB 2.0 Switch