HV2818 Series

32Ch High Voltage Multiplexer w/+5V bias

Catalog

32Ch High Voltage Multiplexer w/+5V bias

Part	Current - Leakage (IS(off)) (Max)	Number of Circuits	Charge Injection	Supplier Device Package	Channel Capacitance (CS(off), CD(off)) [custom]	Channel Capacitance (CS(off), CD(off)) [custom]	-3db Bandwidth	On-State Resistance (Max) [Max]	Package / Case	Switch Time (Ton, Toff) (Max) [custom]	Switch Time (Ton, Toff) (Max) [custom]	Crosstalk	Voltage - Supply, Single (V+) [Max]	Voltage - Supply, Single (V+) [Min]	Switch Circuit	Multiplexer/Demultiplexer Circuit	Operating Temperature [Max]	Operating Temperature [Min]	Mounting Type
Microchip Technology HV2818/R4X	3 µA	16	100 pC	64-VQFN (9x9)	21 pF	21 pF	50 MHz	9 Ohm	64-VFQFN Exposed Pad	5 µs	5 µs	-70 dB	6.3 V	4.5 V	SPDT	2:1	70 °C	0 °C	Surface Mount

Catalog

32Ch High Voltage Multiplexer w/+5V bias

Key Features

• * 32-Channel 16X2:1 Multiplexer

• * +5V Bias Supply

• * +/-100V Passing Signal

• * 3.3V and 5V CMOS Input Logic Levels

• * 66MHz Data Shift Clock Frequency

• * Low-Parasitic Capacitance

• * Low-Harmonic Distortion

• * 200KHz to 50MHz Large Signal Frequency

• * DC-50MHz Analog Small-Signal Frequency

• * Excellent Noise Immunity

• * -70dB Typical Off Isolation at 5MHz

• * Cascadable Serial Data Register with Latches

Description

The HV2818 is a low harmonic distortion, low charge injection, 16X2:1 high-voltage analog multiplexer/demultiplexer with only a +5V bias supply. All the switch channels can pass up to ±100V high-voltage pulsed signals however not a DC. They are intended for use in applications requiring high-voltage switching by low voltage controls, such as ultrasound imaging, piezoelectric transducer drivers and printers. The HV2818 is pin-to-pin compatible to its high-voltage biased counterpart, HV2801, except for bias pins. The HV2818 has an 2.7A high peak-current performance in a 64-lead, 9 mm x 9 mm QFN package. The SW pin can pass high-voltage pulsed signals when the switch is ON. During the OFF state, no high-voltage signals should be applied to the SW pin. The ON/OFF state of the 32 switches can be programmed individually through a digital serial interface. The device has a typical 6Ω ON resistance and a 50 MHz bandwidth for small signals. The HV2818 does not have the bleed resistors at SW pins.