HV2605 Series

16-Channel Low Harmonic Distortion High Voltage Analog Switch

Catalog

16-Channel Low Harmonic Distortion High Voltage Analog Switch

Part	Multiplexer/Demultiplexer Circuit	Switch Circuit	Package / Case	Number of Channels	Voltage - Supply, Single (V+) [Min]	Voltage - Supply, Single (V+) [Max]	Applications	On-State Resistance (Max) [Max]	Voltage - Supply, Dual (V±) [Max]	Voltage - Supply, Dual (V±) [Min]	Mounting Type	Supplier Device Package	Operating Temperature [Max]	Operating Temperature [Min]	-3db Bandwidth	On-State Resistance (Max)
Microchip Technology HV2605FG-G	1:1	SPST	48-LQFP	16	40 V	200 V	Ultrasound	38 Ohm	160 V	-40 V	Surface Mount	48-LQFP (7x7)	70 °C	0 °C	50 MHz
Microchip Technology HV2605TQ-G	1:1	SPST	48-TQFP	16	3 V	5.5 V	Ultrasound				Surface Mount	48-TQFP (7x7)	70 °C	0 °C		48 Ohm

Catalog

16-Channel Low Harmonic Distortion High Voltage Analog Switch

Key Features

• * HVCMOS technology for high performance

• * 16-channel high voltage analog switch

• * 3.3V input logic level compatible

• * 20MHz data shift clock frequency

• * Very low quiescent power dissipation (-10µA)

• * Low parasitic capacitance

• * DC to 50MHz small signal frequency response

• * -60dB typical off-isolation at 5.0MHz

• * CMOS logic circuitry for low power

• * Low harmonic distortion

• * Cascadable serial data register with latches

• * Flexible operating supply voltages

Description

HV2605 is a low charge injection 16-channel high voltage analog switch integrated circuit (IC) intended for use in applications requiring high voltage switching controlled by low voltage control signals, such as medical ultrasound imaging and other piezoelectric transducer drivers. Input data are shifted into a 16-bit shift register that can then be retained in a 16-bit latch. To reduce any possible clock feed through noise, the latch enable bar should be left high until all bits are clocked in. Data are clocked in during the rising edge of the clock. Using HVCMOS technology, this device combines high voltage bilateral DMOS switches and low power CMOS logic to provide efficient control of high voltage analog signals. The device is suitable for various combinations of high voltage supplies, e.g., VPP/VNN: +40V/-160V, +100V/-100V, and +160V/-40V. \*The LQFP package is not recommended for new design. Please use TQFP package as an alternative.