Specification	TPS78825DBVR

Control Features	Enable
Current - Output	150 mA
Current - Quiescent (Iq)	385 µA
Mounting Type	Surface Mount
Number of Regulators	1
Operating Temperature [Max]	85 °C
Operating Temperature [Min]	-40 °C
Output Configuration	Positive
Output Type	1.81 mOhm
Package / Case	SC-74A, SOT-753
Protection Features	Over Temperature, Reverse Polarity, Over Current
PSRR	70 dB
Supplier Device Package	SOT-23-5
Voltage - Input (Max) [Max]	10 V
Voltage - Output (Min/Fixed)	2.5 V
Voltage Dropout (Max) [Max]	0.3 V

TPS78833 Series

150-mA, 10-V, low-IQ, low-dropout voltage regulator with enable

Part	Voltage - Input (Max) [Max]	Supplier Device Package	Package / Case	Control Features	Output Configuration	Voltage - Output (Min/Fixed)	Protection Features	Current - Quiescent (Iq)	Number of Regulators	PSRR	Output Type	Mounting Type	Voltage Dropout (Max) [Max]	Operating Temperature [Max]	Operating Temperature [Min]	Current - Output	Voltage - Input [Min]	Voltage - Input [Max]	Channels per IC	Board Type	Regulator Type	Supplied Contents	Voltage - Output	Utilized IC / Part
Texas Instruments TPS78825DBVT	10 V	SOT-23-5	SC-74A SOT-753	Enable	Positive	2.5 V	Over Current Over Temperature Reverse Polarity	385 µA	1	70 dB	1.81 mOhm	Surface Mount	0.3 V	85 °C	-40 °C	150 mA
Texas Instruments TPS78825DBVR	10 V	SOT-23-5	SC-74A SOT-753	Enable	Positive	2.5 V	Over Current Over Temperature Reverse Polarity	385 µA	1	70 dB	1.81 mOhm	Surface Mount	0.3 V	85 °C	-40 °C	150 mA
Texas Instruments TPS78833DBVR	10 V	SOT-23-5	SC-74A SOT-753	Enable	Positive	3.3 V	Over Current Over Temperature Reverse Polarity	385 µA	1	70 dB	1.81 mOhm	Surface Mount	0.3 V	85 °C	-40 °C	150 mA
Texas Instruments TPS78833EVM																150 mA	2.7 V	13.5 V	1 - Single	Fully Populated	Positive Fixed	Board(s)	3.3 V	TPS78833
Texas Instruments TPS78833DBVT	10 V	SOT-23-5	SC-74A SOT-753	Enable	Positive	3.3 V	Over Current Over Temperature Reverse Polarity	385 µA	1	70 dB	1.81 mOhm	Surface Mount	0.3 V	85 °C	-40 °C	150 mA

Pricing

Prices provided here are for design reference only. For realtime values and availability, please visit the distributors directly

Distributor	Package	Quantity	$

Digikey	Cut Tape (CT)	1	$ 5.56
		10	$ 3.73
		25	$ 3.25
		100	$ 2.72
		250	$ 2.46
		500	$ 2.30
		1000	$ 2.17
	Digi-Reel®	1	$ 5.56
		10	$ 3.73
		25	$ 3.25
		100	$ 2.72
		250	$ 2.46
		500	$ 2.30
		1000	$ 2.17
	Tape & Reel (TR)	3000	$ 1.77
Texas Instruments	LARGE T&R	1	$ 3.61
		100	$ 2.98
		250	$ 2.14
		1000	$ 1.61

Description

General part information

TPS78833 Series

The TPS78825 and TPS78833 are very small (SOT-23) package, low-noise LDOs that regulate the output voltage to 2.5 V and 3.3 V with input voltage ranging from 2.7 V to an absolute maximum of 13.5 V. These devices output 150 mA with a peak current of 350 mA (typ). The TPS788xx family uses the SR pin to program the output voltage slew rate to control the in-rush current. This is specifically used in the USB application where large load capacitance is present at start-up. The TPS788xx devices use only 17 uA of quiescent current and exhibit only 56 uVRMSof output voltage noise using a 10 uF output capacitor.

The usual PNP pass transistor has been replaced by a PMOS pass element. Because the PMOS pass element behaves as a low-value resistor, the dropout voltage is very low, typically 150 mV at 150 mA of load current, and is directly proportional to the load current.

The TPS788xx also features a logic-enabled sleep mode to shut down the regulator, reducing quiescent current to 1 uA typical at TJ= 25°C.

Documents

Technical documentation and resources

150-mA Low-Noise LDO with In-Rush Current Control for USB Application datasheet (Rev. A)

Data sheet