Specification	TPS3513D

Mounting Type	Surface Mount
Number of Voltages Monitored	3
Operating Temperature [Max]	85 °C
Operating Temperature [Min]	-40 °C
Output	Open Drain or Open Collector
Package / Case	14-SOIC
Package / Case [x]	0.154 in
Package / Case [y]	3.9 mm
Reset	Active Low
Reset Timeout	200 ms
Type	Multi-Voltage Supervisor
Voltage - Threshold	3.3 V, 5 V, 12 V

TPS3513 Series

3-channel supervisor with overcurrent detect for switch-mode power supplies

Part	Number of Voltages Monitored	Reset	Operating Temperature [Max]	Operating Temperature [Min]	Mounting Type	Reset Timeout	Voltage - Threshold	Type	Output	Package / Case [x]	Package / Case [y]	Package / Case
Texas Instruments TPS3513D	3	Active Low	85 °C	-40 °C	Surface Mount	200 ms	3.3 V 5 V 12 V	Multi-Voltage Supervisor	Open Drain or Open Collector	0.154 in	3.9 mm	14-SOIC
Texas Instruments TPS3513N	3	Active Low	85 °C	-40 °C	Through Hole	200 ms	3.3 V 5 V 12 V	Multi-Voltage Supervisor	Open Drain or Open Collector	0.3 "	7.62 mm	14-DIP
Texas Instruments TPS3513DR	3	Active Low	85 °C	-40 °C	Surface Mount	200 ms	3.3 V 5 V 12 V	Multi-Voltage Supervisor	Open Drain or Open Collector	0.154 in	3.9 mm	14-SOIC

Pricing

Prices provided here are for design reference only. For realtime values and availability, please visit the distributors directly

Distributor	Package	Quantity	$

Texas Instruments	TUBE	1	$ 2.63
		100	$ 2.30
		250	$ 1.61
		1000	$ 1.30

Description

General part information

TPS3513 Series

The TPS3513 is designed to optimize PC switching power supply system with minimum external components. It provides undervoltage lockout (UVLO), protection circuits, power good indicator, and on/off control.

UVLO thresholds are 4.45 V (on) and 3.65 V (off). Overcurrent protection (OCP) and overvoltage protection (OVP) monitor 3.3 V, 5 V, and 12 V. When an OC or OV condition is detected, the power-good output (PGO) is asserted low and the fault protection output (FPO) is latched high.PSONfrom low-to-high resets the latch. The OCP function will be enabled 75 ms afterPSONgoes low, and a debounce of typically 38 ms. A built-in 2.3-ms delay with 38-ms debounce fromPSONtoFPOoutput is enabled at turnoff.

An external resistor is connected between the RI pin and the GND pin. This will introduce an accurate I(ref)for OCP function. The I(ref)range is from 12.5 µA to 62.5 µA. The formula for choosing RI resistor is V(RI)/I(ref). Three OCP comparators and the I(ref)section are supplied by VS12. The current draw from the VS12 pin is less than 1 mA.

Documents

Technical documentation and resources

PC-Power Supply Supervisor datasheet (Rev. B)

Data sheet