D
Diodes Inc
| Series | Category | # Parts | Status | Description |
|---|---|---|---|---|
| Part | Spec A | Spec B | Spec C | Spec D | Description |
|---|---|---|---|---|---|
Beta
⌘K
| Series | Category | # Parts | Status | Description |
|---|---|---|---|---|
| Part | Spec A | Spec B | Spec C | Spec D | Description |
|---|---|---|---|---|---|
| Part | Category | Description |
|---|---|---|
 Diodes Inc ZXSC100X8TAObsolete | Integrated Circuits (ICs) | SWITCHING CONTROLLER, VOLTAGE-MODE, 200KHZ SWITCHING FREQ-MAX, PDSO8, MSOP-8 |
 Diodes Inc MBR1045Obsolete | Discrete Semiconductor Products | DIODE SCHOTTKY 45V 10A TO220AC |
 Diodes Inc | Discrete Semiconductor Products | TRANS GP BJT NPN 45V 0.1A 3-PIN SOT-23 T/R |
 Diodes Inc | Crystals Oscillators Resonators | CRYSTAL 25MHZ FUND 60OHM 4-PIN MINI-CSMD |
 Diodes Inc | Crystals Oscillators Resonators | XTAL OSC XO 133.0000MHZ CMOS SMD |
 Diodes Inc | Discrete Semiconductor Products | DIODE GEN PURP 100V 1A DO41 |
Diodes Inc MBRF20150CTLObsolete | Discrete Semiconductor Products | DIODE SCHOTTKY ITO220AB |
 Diodes Inc | Integrated Circuits (ICs) | NRND = NOT RECOMMENDED FOR NEW DESIGN |
 Diodes Inc | Discrete Semiconductor Products | 1.1V@2A 240NS INDEPENDENT TYPE 1A 1KV SOD-123F FAST RECOVERY / HIGH EFFICIENCY DIODES ROHS |
 Diodes Inc | Integrated Circuits (ICs) | ANALOGUE SW, SPDT, -40 TO 125DEG C ROHS COMPLIANT: YES |
| Series | Category | # Parts | Status | Description |
|---|---|---|---|---|
| Analog Switches - Special Purpose | 2 | Obsolete | ||
PI2SSD32121.35V/ 1.5V/1.8V 14 bit 2:1 SSD Switch | Interface | 3 | Obsolete | This 14-bit SSD switch is designed for 1.35V/ 1.5V/ 1.8V supply voltage, POD_12, SSTL_135, SSTL_15 or SSTL_18 signaling and CMOS select input signals. It is designed for DDR2 or DDR3 memory bus with speed up to 5Gbps.It supports DDR3 1866 Mbps.PI2SSD3212 has a 1:2 demux or 2:1 mux topology. All 14-bit channels can be switched to one of the two ports simultaneously with the SEL input. This device also allows all ports to be disconnected. PI2SSD3212 uses Diodes' proprietary high speed switch technology providing consistent high bandwidth across all channels, with very little insertion loss, cross-talk, and bit to bit skew. It is available in a 52-pin TQFN 3.5x9x0.4mm package and 48-pin TFBGA 4.5x4.5x0.8mm package. |
PI2USB4122 (Not Recommended for New Design (NRND))NRND = Not Recommended for New Design | Analog Switches - Special Purpose | 1 | LTB | NRND = Not Recommended for New Design |
PI3A125BNRND = Not Recommended for New Design | Analog Switches, Multiplexers, Demultiplexers | 2 | Active | NRND = Not Recommended for New Design |
| Analog Switches - Special Purpose | 1 | Obsolete | ||
PI3A223Dual SPDT with 0.6-ohm Ron | Integrated Circuits (ICs) | 1 | Active | Dual SPDT with 0.6-ohm Ron |
PI3A2268Dual SPDT with 0.45-ohm Ron | Interface | 1 | Obsolete | Dual SPDT with 0.45-ohm Ron |
PI3A268CDual SPDT with 0.6-ohm Ron and -1.5V Support | Interface | 1 | Active | The PI3A268C is a dual, fast single-pole double throw (SPDT) CMOS switch with negative signal handling capability at all ports. It can be used as an analog switch or as a low-delay bus switch. Operating over a wide power supply voltage ranges from 2.5V to 4.3V, the PI3A268C processes a low on-resistance and distortion. Break-before-make switching prevents both switches being enabled simultaneously. This eliminates signal disruption during switching. |
PI3A288Ultra-Low-THD Dual-SPDT (0.35Ω) Analog Switch with Negative Signal Handling Capability | Analog Switches, Multiplexers, Demultiplexers | 1 | Active | Ultra-Low-THD Dual-SPDT (0.35Ω) Analog Switch with Negative Signal Handling Capability |
| Interface | 1 | Obsolete | ||