CAT5132 Series

Digital Potentiometer (POT), 128-Tap, with I2C Interface

Catalog

Digital Potentiometer (POT), 128-Tap, with I2C Interface

Part	Voltage - Supply [Max]	Voltage - Supply [Min]	Number of Taps	Tolerance	Taper	Resistance (Ohms)	Memory Type	Supplier Device Package	Mounting Type	Temperature Coefficient (Typ)	Resistance - Wiper (Ohms) (Typ)	Configuration	Package / Case	Package / Case [x]	Package / Case [x]	Interface	Operating Temperature [Max]	Operating Temperature [Min]	Features	Number of Circuits
ON Semiconductor CAT5132ZI-00-GT3	5.5 V 16 V	2.7 V 8 V	128	20 %	Linear	100 kOhms	Non-Volatile	10-MSOP	Surface Mount	300 ppm/°C	110 Ohms	Potentiometer	10-MSOP 10-TFSOP	3 mm	0.118 in	I2C	85 °C	-40 °C	Selectable Address	1
ON Semiconductor CAT5132ZI-50-GT3	5.5 V 16 V	2.7 V 8 V	128	20 %	Linear	50 kOhms	Non-Volatile	10-MSOP	Surface Mount	300 ppm/°C	110 Ohms	Potentiometer	10-MSOP 10-TFSOP	3 mm	0.118 in	I2C	85 °C	-40 °C	Selectable Address	1

Catalog

Digital Potentiometer (POT), 128-Tap, with I2C Interface

Key Features

• Single linear digital POT with 128 taps

• End-to-end resistance of 10 kΩ, 50 kΩ & 100 kΩ

• I²C interface

• Fast Up/Down wiper control mode

• Automatic wiper setting recall at power up

• Non-volatile wiper setting storage

• Digital Supply range (VCC): 2.7 V to 5.5 V

• Analog Supply range (V+): +8.0 V to +16 V

• Low Standby Current: 15 µA

• 100 Year wiper setting memory

• Industrial Temperature range: -40°C to +85°C

Description

The CAT5132 is a high voltage digital POT with non-volatile wiper setting memory, operating like a mechanical potentiometer. The tap points between the 127 equal resistive elements are connected to the wiper output via CMOS switches. The switches are controlled by a 7-bit Wiper Control Register (WCR). The wiper setting can be stored in a 7-bit non-volatile Data Register (DR). The WCR is accessed via the I²C serial bus.Upon power-up, the WCR is set to mid-scale (1000000). After the power supply is stable, the contents of the DR are transferred to the WCR and the wiper is returned to the memorized setting.The CAT5132 has two voltage supplies: VCC, the digital supply and V+, the analog supply. V+ can be much higher than VCC, allowing for 16V analog operations.The CAT5132 can be used as a potentiometer or as a two-terminal variable resistor.